The purpose of Replicate Seed Data Concurrent Program is to populate the Installed modules seeded values, so that new organizations can use the seeded data.
Whenever new Organizations are created (under the Multi-org Setup), running Replicate Seed data is a pre-requisite step before you can start working in the newly created organization.
The Replicate Seed Data Concurrent Program can be run for a particular Operating Unit or for all Operating Units (as it is not mandatory parameter) but you cannot run the program for a particular module.
The concept of the program is that whenever new organizations are created they should be should have seeded data from all relevant modules for normal integration among the modules. The seeded data is basic data needed to perform basic steps when setting up a new organization.
Running this program will not damage the system because it is providing a new organization with the basic information required to set up the organization.
This progromme we need to run in System Administrator responsibility.
Seed data replicaiton program works in two modes
- Single organization - Pariticular Operating Unit.
- All Organizations - This mode applies when the seed data replication program is executed without an operating unit.
Make sure no user is logged in while running this program.